Unipolar Boost Converter

• Part Number: ELC-UVB040
• Dimensions: 10.4 x 20.5 x 5.5 mm (.41 x .81 x 0.21") (L x W x Th).
• Minimum input voltage: 40mV (0.040 volts)
• Maximum input voltage: 1.0 volts.
• Maximum output voltage: 10.0 volts.
• Weight:: 1.75 gram

Unipolar Boost Converter

This DC/DC Voltage Booster circuit takes very low input voltage and converts it up to a more usable voltage so you can light an LED or charge a battery.

• Unipolar input. [you must connect the input wires correctly or else it will not function].
• Starts boosting when the input voltage is 40mV or higher.
• Output is 1 to 10 volts depending on input voltage and load.
• Built in Zener diode clamps maximum output to 10 volts.
• On-board jumper allows selection of 5 volt clamped output.
• Very small package size, about the size of a 16 pin DIP socket.
• High efficiency DC to DC conversion
• Ready for you to attach lead wires (not included) on both input and ouput.
• Developed in cooperation with TXL Group, a leading manufacturer of thermoelectric solutions for capturing waste heat energy.
• This is the same voltage booster used on our Hand Heat Demonstration. It will light an LED using just the heat from your hand.